PE/PW Bypass Simulator for the L18050: No Tape, Any Film, the Printer Never Asks for Paper. A DIY Kit Shipped Worldwide

Published 1 November 2023

Here is the L18050 with its board exposed, a stack of green simulator boards on the bench, and the printer starting a roll print without once asking for paper. That is the PE/PW bypass simulator: no tape, any film, AcroRIP 11.2, roll or sheet. In November 2023 we began shipping it as a complete DIY kit, board, FFC cables and a fitting video, to converters outside India. Fifty-five seconds, and the whole point is in the last ten.

Clip, 55 s. November 2023. · Watch on YouTube

What the video shows

  1. 0:00 — The L18050 with the simulator fitted; no tape, any film
  2. 0:11 — Complete DIY kit: board, FFC cables, video; B2B, global
  3. 0:20 — Speed-drop prevention modules for DTG, UV and DTF too
  4. 0:29 — Print: the printer does not ask for paper
  5. 0:40 — Printing on roll; PE and PW fully bypassed

PE, PW, and tape

PE is the paper-end sensor, PW the paper-width sensor. Both misread clear PET film: the printer thinks there is no paper, or the wrong width, and either refuses the job or ejects the roll at a page end. The tape trick covers the sensor so it always sees paper, which works until the tape shifts or the roll ends in the middle of a job. The simulator replaces the sensor signals at the board, so there is nothing to tape and nothing to shift.

Card: contents and benefits of the L18050 PE PW bypass simulator DIY kit
For converters who fit their own.
Epson L18050 on the bench with its side open and a stack of green PE PW simulator boards in front, caption PE PW simulator 18050
The printer open, simulator boards on the bench.
Close-up of the L18050 mainboard area with the simulator and FFC cable connected
Simulator connected to the board by FFC cable.

The kit

Simulator board, the FFC cables it needs, and a DIY fitting video. B2B only: this is for converters and shops that do their own work. We also supply the speed-drop prevention module for DTG, UV and DTF printers, usually fitted at the same time, so a roll runs at full speed and never stops for a sensor.

Open L18050 with the carriage and board visible and the DIY kit boards beside it
Board exposed; the kit sits beside it.

The proof

Hit print. A stock printer would ask for paper; this one starts feeding the roll and printing. PE and PW are completely bypassed; use any quality of film, no tape, AcroRIP custom 11.2 on top. In India the part is sold as the PE/PW bypass module, with the IVFO module beside it; the live no-tape demo is here and the full conversion guide here.

L18050 printing from the roll with the carriage moving and the module fitted
Printing from the roll; no paper prompt, no tape.

Frequently asked questions

What does the PE/PW simulator do?

Replaces the paper-end and paper-width sensor signals so the L18050 prints on clear film and rolls without asking for paper.

Do I still need tape on the sheet?

No. That is the point: any film, no tape.

What is in the kit?

Simulator board, FFC cables and a DIY fitting video. B2B supply, shipped worldwide.

Does it fix the speed drop?

No, that is the separate IVFO module, usually fitted at the same time.

Converting L18050s?

Message quantities on WhatsApp for B2B pricing on the simulator and IVFO together.

WhatsApp +91 86555 56060

More videos: Epson L18050 / L8050 DTF conversion